Manuals / Paxar / Computer Equipment / Printer

Paxar 9445 manual Turn the printhead lever to the left to release the printhead

Models: 9445

1 50

Download 50 pages 20.62 Kb

Page 10

2.Turn the printhead lever to the left to release the printhead.

9445 Equipment Manual

Printhead	Lower Supply	Lock
Lever	Guide

2.Turn the printhead lever to the left to release the printhead.

3.Hold down the lower supply guide and rewind the old supply roll, if there is one.

4.Release the lower supply guide.

CAUTION

If you run out of supply while printing, pull the supply strip back through the printer. DO NOT pull it forward through the printhead. Pulling it forward may cause jamming.

2-2

Image 10

Paxar 9445 manual Turn the printhead lever to the left to release the printhead

Contents

Equipment Manual CANADIAN D.O.C. WARNING Handbook PrefaceOperator’s User’s Manual9445 Equipment Manual Table of Contents Appendix A. Converting the Keyboard forSupplies Appendix C. SpecificationsPrinter 9445 Equipment Manual1. Installing the Printer Socket Power Cord RS-232 Cable Non-Peel Mode 2. Loading Supply2. Turn the printhead lever to the left to release the printhead Loading Supplies Supply Core Supply Shaft Outer Supply Holder2. Loading Supply Printable Side Inside a. Remove the hub from the inner supply holderSupply Shaft Inner Supply Holder10. Push the lock to the left to secure the outer supply holder 11. Pull enough supply from the roll to reach the printhead NARROW for supply two inches in width or smaller WIDE for supply greater than two inches in widthPeel Mode Printhead Lever3. If you are reloading supply Printable Side Inside 2-10Supply Shaft Inner Supply Holder2-11 10. Push the lock to the left to secure the outer supply holder2-12 13. Insert the backing paper under the clampLoading Supplies 2-13Labels Backing Paper 2. Loading SupplyNARROW for supply two inches in width or smaller 2-14WIDE for supply greater than two inches in width 2-15 17. Turn the printer on. If you areLoading Fan-Fold Supply 2-162-17 7. Close the printhead by turning the printhead lever to the rightAdjusting the Supply Sensor 2-182-19 Die cut supply requires no sensor adjustment2-20 Adjusting the On Demand SensorOn Demand Sensor 3. Loading a Ribbon Loading a Ribbon Roll 5. Be sure the thermal supply indicator is pointing upward 8. Slide the ribbon spool holders against the spools 14. Close the front panel Loading a Ribbon Cassette Loading a Ribbon Roll 3. Loading a Ribbon5. Guide the edge of the ribbon around the ribbon guide post 4. Adjusting the Display Loading the Ribbon Cassette9445 Equipment Manual 5. Cleaning the Printhead and Platen Roller Cleaning the Printhead and Platen RollerPrinthead Platen Roller 7. Turn the power on 8. Press f twice to realign the supply9. If printing is not improved, call Monarch Service 9445 Equipment ManualAppendix A. Converting the Keyboard for Table Top Use Converting the Keyboard for Table Top Use9445 Equipment Manual Appendix B. Troubleshooting Head Test Failure MessageStart-Up and Printing Start-Up and Printing continued TroubleshootingCutting Appendix C. Specifications PrinterSupplies Page For supplies, service, or assistance call TOLL FREEPrinted in U.S.A