Manuals / Paxar / Computer Equipment / Printer

Paxar 9445 manual Peel Mode, Printhead Lever

Models: 9445

1 50

Download 50 pages 20.62 Kb

Page 16

Peel Mode

9445 Equipment Manual

17.Turn the printer on. If you are:

•replacing the supply with a new roll of the same size, press f to align the printer.

•changing supply size, adjust the supply sensor. See "Adjusting the Supply Sensor" later in this chapter.

NOTE: Before you print, be sure the menu supply type setting matches your supply type (e.g. Black Mark/Die Cut). See your Operator’s Handbook to set supply options.

Peel Mode

This mode is only used with labels. The printer separates the label from the backing paper. This mode must be used with On Demand printing.

1.Open the front panel.

2.Turn the printhead lever to the left to release the printhead.

Printhead

Lever

2-8

Image 16

Paxar 9445 manual Peel Mode, Printhead Lever

Contents

Equipment Manual CANADIAN D.O.C. WARNING Preface Operator’sHandbook User’s Manual9445 Equipment Manual Table of Contents Appendix A. Converting the Keyboard forAppendix C. Specifications PrinterSupplies 9445 Equipment Manual1. Installing the Printer Socket Power Cord RS-232 Cable Non-Peel Mode 2. Loading Supply2. Turn the printhead lever to the left to release the printhead Loading Supplies Supply Core Supply Shaft Outer Supply Holder2. Loading Supply a. Remove the hub from the inner supply holder Supply ShaftPrintable Side Inside Inner Supply Holder10. Push the lock to the left to secure the outer supply holder 11. Pull enough supply from the roll to reach the printhead NARROW for supply two inches in width or smaller WIDE for supply greater than two inches in widthPeel Mode Printhead Lever3. If you are reloading supply 2-10 Supply ShaftPrintable Side Inside Inner Supply Holder2-11 10. Push the lock to the left to secure the outer supply holder2-12 13. Insert the backing paper under the clamp2-13 Labels Backing PaperLoading Supplies 2. Loading SupplyNARROW for supply two inches in width or smaller 2-14WIDE for supply greater than two inches in width 2-15 17. Turn the printer on. If you areLoading Fan-Fold Supply 2-162-17 7. Close the printhead by turning the printhead lever to the rightAdjusting the Supply Sensor 2-182-19 Die cut supply requires no sensor adjustment2-20 Adjusting the On Demand SensorOn Demand Sensor 3. Loading a Ribbon Loading a Ribbon Roll 5. Be sure the thermal supply indicator is pointing upward 8. Slide the ribbon spool holders against the spools 14. Close the front panel Loading a Ribbon Cassette Loading a Ribbon Roll 3. Loading a Ribbon5. Guide the edge of the ribbon around the ribbon guide post 4. Adjusting the Display Loading the Ribbon Cassette9445 Equipment Manual 5. Cleaning the Printhead and Platen Roller Cleaning the Printhead and Platen Roller7. Turn the power on 8. Press f twice to realign the supply 9. If printing is not improved, call Monarch ServicePrinthead Platen Roller 9445 Equipment ManualAppendix A. Converting the Keyboard for Table Top Use Converting the Keyboard for Table Top Use9445 Equipment Manual Appendix B. Troubleshooting Head Test Failure MessageStart-Up and Printing Start-Up and Printing continued TroubleshootingCutting Appendix C. Specifications PrinterSupplies Page For supplies, service, or assistance call TOLL FREEPrinted in U.S.A