Manuals / Paxar / Computer Equipment / Printer

Paxar 9445 manual Start-Up and Printing continued, Troubleshooting

Models: 9445

1 50

Download 50 pages 20.62 Kb

Page 45

Start-Up and Printing (continued)

Appendix B. Troubleshooting

Start-Up and Printing (continued)

Problem	Action


Printed data becomes	Recalibrate the printer. Select Printer
misaligned.	Options from the main menu, then
	select Define Supply Type. Select
	A)lign to recalibrate the printer.

Printed data wraps	Change supply.
around.

	Correct the format in Format Entry
	mode or send a corrected format
	online.

Printing shadows or	Clean the printhead.
smears.

	Change supply.

	Reload ribbon cassette.

Voids in printing.	Clean the printhead.

	Change supply.

	Reload ribbon cassette.

B-3

Troubleshooting

Image 45

Paxar 9445 manual Start-Up and Printing continued, Troubleshooting

Contents

Equipment Manual CANADIAN D.O.C. WARNING Operator’s PrefaceHandbook User’s Manual9445 Equipment Manual Appendix A. Converting the Keyboard for Table of ContentsPrinter Appendix C. SpecificationsSupplies 9445 Equipment Manual1. Installing the Printer Socket Power Cord RS-232 Cable 2. Loading Supply Non-Peel Mode2. Turn the printhead lever to the left to release the printhead Supply Core Supply Shaft Outer Supply Holder Loading Supplies2. Loading Supply Supply Shaft a. Remove the hub from the inner supply holderPrintable Side Inside Inner Supply Holder10. Push the lock to the left to secure the outer supply holder 11. Pull enough supply from the roll to reach the printhead WIDE for supply greater than two inches in width NARROW for supply two inches in width or smallerPrinthead Lever Peel Mode3. If you are reloading supply Supply Shaft 2-10Printable Side Inside Inner Supply Holder10. Push the lock to the left to secure the outer supply holder 2-1113. Insert the backing paper under the clamp 2-12Labels Backing Paper 2-13Loading Supplies 2. Loading Supply2-14 NARROW for supply two inches in width or smallerWIDE for supply greater than two inches in width 17. Turn the printer on. If you are 2-152-16 Loading Fan-Fold Supply7. Close the printhead by turning the printhead lever to the right 2-172-18 Adjusting the Supply SensorDie cut supply requires no sensor adjustment 2-19Adjusting the On Demand Sensor 2-20On Demand Sensor 3. Loading a Ribbon Loading a Ribbon Roll 5. Be sure the thermal supply indicator is pointing upward 8. Slide the ribbon spool holders against the spools 14. Close the front panel Loading a Ribbon Cassette 3. Loading a Ribbon Loading a Ribbon Roll5. Guide the edge of the ribbon around the ribbon guide post Loading the Ribbon Cassette 4. Adjusting the Display9445 Equipment Manual Cleaning the Printhead and Platen Roller 5. Cleaning the Printhead and Platen Roller9. If printing is not improved, call Monarch Service 7. Turn the power on 8. Press f twice to realign the supplyPrinthead Platen Roller 9445 Equipment ManualConverting the Keyboard for Table Top Use Appendix A. Converting the Keyboard for Table Top Use9445 Equipment Manual Head Test Failure Message Appendix B. TroubleshootingStart-Up and Printing Troubleshooting Start-Up and Printing continuedCutting Printer Appendix C. SpecificationsSupplies Page TOLL FREE For supplies, service, or assistance callPrinted in U.S.A