Manuals / Paxar / Computer Equipment / Printer

Paxar 9445 manual Installing the Printer

Models: 9445

1 50

Download 50 pages 20.62 Kb

Page 7

1. Installing the Printer

1. Installing the Printer

1.Place the printer on a level surface.

2.To install the keyboard on top of the printer:

a.Remove the cord from the base of the keyboard.

b.Plug the cord from the keyboard into the socket.

c.Insert all of the cord except a few coils back into the base. Secure the cord by sliding a coil into the slot in the base.

d.Place the keyboard in the recess on top of the printer as shown.

Keyboard

Recess

Socket

Installing the Printer

1-1

Image 7

Paxar 9445 manual Installing the Printer

Contents

Equipment Manual CANADIAN D.O.C. WARNING User’s Manual PrefaceOperator’s Handbook9445 Equipment Manual Appendix A. Converting the Keyboard for Table of Contents9445 Equipment Manual Appendix C. SpecificationsPrinter Supplies1. Installing the Printer Socket Power Cord RS-232 Cable 2. Loading Supply Non-Peel Mode2. Turn the printhead lever to the left to release the printhead Loading Supplies Supply Core Supply Shaft Outer Supply Holder2. Loading Supply Inner Supply Holder a. Remove the hub from the inner supply holderSupply Shaft Printable Side Inside10. Push the lock to the left to secure the outer supply holder 11. Pull enough supply from the roll to reach the printhead WIDE for supply greater than two inches in width NARROW for supply two inches in width or smallerPrinthead Lever Peel Mode3. If you are reloading supply Inner Supply Holder 2-10Supply Shaft Printable Side Inside10. Push the lock to the left to secure the outer supply holder 2-1113. Insert the backing paper under the clamp 2-122. Loading Supply 2-13Labels Backing Paper Loading SuppliesNARROW for supply two inches in width or smaller 2-14WIDE for supply greater than two inches in width 17. Turn the printer on. If you are 2-152-16 Loading Fan-Fold Supply7. Close the printhead by turning the printhead lever to the right 2-172-18 Adjusting the Supply SensorDie cut supply requires no sensor adjustment 2-192-20 Adjusting the On Demand SensorOn Demand Sensor 3. Loading a Ribbon Loading a Ribbon Roll 5. Be sure the thermal supply indicator is pointing upward 8. Slide the ribbon spool holders against the spools 14. Close the front panel Loading a Ribbon Cassette 3. Loading a Ribbon Loading a Ribbon Roll5. Guide the edge of the ribbon around the ribbon guide post Loading the Ribbon Cassette 4. Adjusting the Display9445 Equipment Manual Cleaning the Printhead and Platen Roller 5. Cleaning the Printhead and Platen Roller9445 Equipment Manual 7. Turn the power on 8. Press f twice to realign the supply9. If printing is not improved, call Monarch Service Printhead Platen RollerConverting the Keyboard for Table Top Use Appendix A. Converting the Keyboard for Table Top Use9445 Equipment Manual Head Test Failure Message Appendix B. TroubleshootingStart-Up and Printing Troubleshooting Start-Up and Printing continuedCutting Printer Appendix C. SpecificationsSupplies Page For supplies, service, or assistance call TOLL FREEPrinted in U.S.A