56 C1553M-B (4/05)
Recording
This portion of the Properties tab applies to PelcoNet NET350 encoders only. If the PelcoNet device has built-in ability to record audio and video,
click “This unit has an integral recording capability.”
To use the recording feature you must set the PelcoNet device’s time zone and clock to ensure that you can locate video archived using the
integral recording capability. Note the following parameters:
•Time zone: Set the time zone on the PelcoNet device to the time zone where the PelcoNet device is installed.
•Clock: Set the clock on the PelcoNet device to the local time where the PelcoNet device is installed, without compensating for Daylight
Saving Time (DST). If you set the PelcoNet’s clock when DST is in effect (during the summer), set the clock one hour behind DST.
Refer to the appropriate PelcoNet manual for instructions on setting the device’s time zone and clock.
Miscellaneous
Use this portion of the Properties tab to configure the PelcoNet device’s internal settings.
1. Click Go. The PelcoNet Device Control window appears.
Figure 51. PelcoNet Device Control Window
2. Configure the PelcoNet device’s internal settings as necessary. When you have finished, click Done to close the window. Refer to the
appropriate PelcoNet manual for information on the device’s internal settings.
RECORDING NOTES:
•To display internally-archived video in a custom window, the window’s canvas must be configured to display the Internal Storage
signal type. For instructions on configuring the canvas, refer to the Canvases section.
•When integral recording capability is selected, the PelcoNet_HDD property becomes available for use in scripts and expressions.
Refer to the Scripts and Expressions section for more information.