Pentax 14161, 14191, 14176 specifications TakingPictures

Drive Mode

Remote Control

and press

3 TakingPictures

2 Use the four-way controller (45) to select i the four-way controller (3).

3 Use the four-way controller (45) to select i or h and press the 4 button.

The self-timer lamp begins to blink slowly and the camera is ready to take

a picture with the remote control. MENU CancelOK OK When the camera detects a person’s

face, the Face Detection function is activated and the face detection frame appears (p.72).

4 Point the remote control at the remote control receiver and press the shutter release button on the remote control.

The focus frame turns green when the subject is in focus and the camera takes a picture at the following timing.

When i (3-sec Remote Control) is selected:

The self-timer lamp blinks quickly and the camera takes a picture after about three seconds.

When h (0-sec Remote Control) is selected: The camera takes a picture immediately.

• The operating range is approx. 4 m (13 ft) from the front of the camera when using the remote control unit.

•In C (Movie) mode, pressing the shutter release button again stops the recording.

•The camera takes a picture even if the focus is not achieved.

•If the shutter release button on the camera is pressed halfway during the countdown, the countdown stops. If the shutter release button on the remote control is pressed again, the camera starts the countdown again.

•i/hcannot be selected in 9 (Green) mode.

•The self-timer lamp does not flash in e(Pet) mode.

96