50

• Do not use the provided battery charger D-BC90 to charge batteries other than D-LI90. Charging other batteries may cause damage or heating.

•Replace the battery with a new one in the following cases:

-If the indicator lamp blinks or does not light after the battery is inserted correctly

-If the battery starts to run down more quickly even after being charged (the battery may have reached the end of its service life)

2 GettingStarted

The maximum charging time is approximately 390 minutes (it depends on temperature and remaining battery power.) Charge in a location where the temperature is between 0°C and 40°C.

Inserting/Removing the Battery

• Do not open the battery cover or remove the battery while the power is on.

•Insert the battery correctly. Inserting the battery incorrectly may cause a camera breakdown. Wipe the electrodes of the battery with a soft dry cloth before inserting.

•Be careful as the camera or battery may become hot when the camera is used continuously for a long period of time.

•Remove the battery when you will not use the camera for a long while. The battery may leak and damage the camera if left installed during prolonged periods of non-use. If the removed battery will not be used for six months or longer, charge the battery for about 30 minutes before storing it. Be sure to recharge the battery every six to twelve months.

•Store the battery in a location where the temperature will remain below room temperature. Avoid locations with high temperatures.

•The date and time may be reset if you leave the battery out of the camera for long periods of time. If this occurs, follow the procedure described in “Setting the Date and Time” (p.62) to set the current date and time.

1 Open the battery cover.

Lift the battery cover unlock knob, turn it towards OPEN (1) to unlock, and then pull the cover open (2).

1 2