Flash Compensation Value
-2.0,-1.7,-1.3,-1.0,-0.7,-0.3, 0.0, +0.3, +0.7, +1.0
-2.0,-1.5,-1.0,-0.5, 0.0, +0.5, +1.0

Compensating for Flash Output

You can change the flash output in the range of -2.0 to +1.0. The flash compensation values are as follows for 1/3 EV and 1/2 EV.

Step Interval

1/3 EV

1/2 EV

Set interval of steps in [1. EV Steps] of the [ACustom Setting 1] menu. (p.106)

71

1 Turn the rear e-dial (S) in the [Flash Mode] screen.

The flash compensation value is displayed.

Press the button to reset the flash output compensation value to 0.0.

Flash Mode

Flash On

+0.3

MENU Cancel

OK OK

3 BasicOperations

•The flash output compensation cannot be set in B(Green) mode.

•Nappears in the viewfinder and on the LCD panel during the flash output compensation. (p.36, p.38)

•When the flash output exceeds its maximum amount, the compensation will not be effective even if the compensation value is set to the plus (+) side.

•Compensating to the minus (-) side may not affect the image if the subject is too close, the aperture value is small or the sensitivity is high.

•The flash output compensation is also effective for external flash units which support the P-TTL auto flash mode.

Enabling Shooting while Charging the Flash

You can set the camera to enable shooting while the built-in flash is charging.

Set [20. Release While Charging] to [On] in the [ACustom Setting 3] menu. By default, pictures cannot be taken while the built-in flash is charging.

20. Release While Charging

1Off 2 On

Enables shutter release while the built-in flash is charging

MENU Cancel

OK OK