IP 300 User Manual
static ip: Select this item to authorize users set IP address, subnet mask and router IP address of IP phone manually.
dhcp: Select this item to enable DHCP mode. With this system, your LAN or router automatically assigns all the required network parameters to any device connected to it when the device log on. IP 300 IP phone is shipped from the factory with DHCP on. So, if your LAN or router is configured to use DHCP addressing, the IP phone’s LAN parameters will automatically configure as soon as it is connected to the LAN or router and powered up.
pppoe The users using ADSL and Cable Modem may select this item, for it is a protocol especially designed for them. With this system, ADSL ISP automatically assigns all the required IP parameters to any device connected to it when the device log on.
modem If the IP phone used with modem, please select this item to get relevant network parameters auto. Then please fill ID and pin into ppp id and
ppppin fields.
ppp id: With pppoe or modem selected in iptype drop down list, please enter the user name here.
ppp pin: With pppoe or modem selected in iptype drop down list, please enter the password here.
local ip: With static ip selected in iptype drop down list, please enter IP address of IP phone here.
subnet mask: With static ip selected in iptype drop down list, please enter subnet mask of IP phone here.
router ip: With static ip selected in iptype drop down list, please enter router
18
