NetCam2 _ii_00592en.qxd | 1/23/03 2:22 PM Page 11 | |
| NetCam2 | Section 2 |
2INSTALLATION
2.1Installation summary
•Connect Ethernet and power to the NetCam2 on a local network for configuration (see 2.1.3).
•Install the setup program for NetCam2 (see 2.2).
•Assign an IP address to NetCam2 and configure its network settings (see 2.3).
•Configure the operational settings (see 2.4).
•Install NetCam2 in its location, and
•Adjust the focus (see section 6).
2.1.1System requirements
•Operating system: Windows 98, ME, NT4 or 2000
•CPU: Pentium II or above
•Minimum RAM: 128MB (Windows 98 and ME), 192MB (windows NT4 and 2000)
•Ensure that either Internet Explorer 5.0 (or above) or Netscape Navigator 4.7 (or above) web browsers are available
2.1.2Recommended PC display settings
Using the Windows ‘Setting / Control Panel / Display’ options, set:
•Color option to ‘High color’
•Screen resolution to 1024x768 pixels.
2.1.3Connecting Ethernet and power cables
•Connect an Ethernet LAN cable to the ‘Ethernet’ port
•Connect the power supply (12V, 1.5 A adaptor, supplied) to the connector marked ‘DC 12 V’ or use an alternative power supply unit on the AC 24 V or the DC 12 V connector.
•Confirm that the green LED on the Ethernet port flashes every 1 to 2 seconds. Note it starts flashing 5 to 6 seconds after applying power.
11