NetCam2 _ii_00592en.qxd | 1/23/03 2:22 PM Page 44 | |
| NetCam2 | Section 4 |
4.2.9Serial Configuration
•Serial Port Selection – select a serial port to configure. NetCam2 has two serial ports. Serial #1 is a RS232C interface port, and Serial #2 is a RS485
•Select Attached Device: selects a communication protocol that an attached external device uses. Any pan/tilt that satisfies the listed protocols may be used. The other choices are:
•None – disables the serial port function.
•Audio device – reserved for future use.
•Modem – for connecting an external PSTN model.
•Manual – to allow manual entry of PTZ commands (contact your supplier for assistance).
•Selection for Philips PTZ:
Baud: 9600, Parity: None, Stopbit: 1, Databit: 8
44