Philips ii00592en.qxd 1/23/03, PM Page, 4.2.10, Digital Input Configuration, NetCam2

NetCam2		_ii_00592en.qxd 1/23/03	2:22 PM Page 45
	NetCam2		Section 4
4.2.10		Digital Input Configuration

The sensor (alarm) inputs comprise LED type photo-couplers. The specification of the input is 5 to 12 Vdc at 10 to 20 mA

Recommendation: Activate the sensor inputs in one of the following ways;

1.Connect sensor input minus (SEN-) to ground (GND) and use a relay or switch to connect

the sensor input plus (SEN+) to +12 V (POW).

2.Connect sensor input plus (SEN+) to +12 V (POW) and use a relay or switch to connect the sensor input minus (SEN-) to ground (GND).

NetCam2 sends e-mails or/and files when connected external sensors detects an event.

•Active State for Input Port 1 – define the normal state of connected input devices such as infrared sensors.

•Current Status for Input Port 1 – NetCam2 shows the current state of the two connected digital devices. Their states are defined at ‘Active State for Input Port 1 and 2’ menus.

45