Philips installation instructions NetCam2, arp -s 200.243.232.178 00-40-8c-10-00-86 ping -t

NetCam2 _ii_00592en.qxd		1/23/03 2:22 PM Page 15
	NetCam2	Section 2

1.Using ARP in Windows 98 and NT

•Start a DOS window and type the following commands.

arp -s <NetCam2 IP address> <NetCam2 _________ address> ping -t <NetCam2 IP address>

•Example

arp -s 200.243.232.178 00-40-8c-10-00-86 ping -t 200.243.232.178

2.Using ARP in Windows 95

•Start a DOS window and type the following commands.

arp -s <NetCam2 IP add.> <NetCam2 Ethernet add.> <my PC IP add.> ping <NetCam2 IP address>

•Example

arp -s 200.243.232.178 00-40-8c-10-00-86 200.243.232.130 ping 200.243.232.178

3.Verifying installation

After completion, the following message (or similar) will be displayed after the ping command:

Request timed out

:

Request timed out

Reply from 200.243.232.178: bytes=32 time=2ms TTL=255

Reply from 200.243.232.178: bytes=32 time=2ms TTL=255

Ping statistics for 200.243.232.178:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milliseconds:

Minimum = 1ms, Maximum = 2ms, Average = 1ms

•If you cannot receive the reply by the 'ping' command, try again by pressing 'F3' and 'Enter' keys again. Normally ‘Request timed out’ messages appear 7 times before you receive proper reply.

15