NetCam2 _ii_00592en.qxd | 1/23/03 2:22 PM Page 33 | |
| NetCam2 | Section 4 |
•DHCP Client Protocol
•If enabled, the NetCam2 automatically sets all addresses by detecting them from the DNCP server. The detected addresses are not shown on the screen.
•If disabled, the administrator must configure all information on network addresses.
•Select Network Interface
•Select 'Ethernet' if the NetCam2 is connected with Internet via a dedicated line, cable modem line or LAN environment.
•Select 'xDSL(PPPoE)' if NetCam2 is connected to an xDSL line that needs a PPPoE process to connect to Internet.
•Select PSTN(Dial Out) if NetCam2 is connected on a network with a PSTN modem.
Ethernet Interface
•IP Address – enter IP address.
•Subnet mask – enter Subnet mask address.
•Broadcast Address – click on ‘Get From Netmask’ button after assigning the IP address and Network Mask address and the broadcast address is automatically set.
Note: If addresses are incorrectly assigned, the NetCam2 cannot be accessed.
•DNS Server IP Address – this is used when NetCam2 is registered on the dynamic IP registration list of the Netcam registration server.
33
