Philips CCC134 Turning On the TV/VCR, Press the Menu button. The screen shown below will appear

8 Turning On the TV/VCR

Before you turn on the TV/VCR, make sure batteries are in the remote control and you have connected the TV/VCR correctly. The instructions on this page work only when you turn on the TV/VCR for the first time.

1

Press the COMBI button, then press the POWER button. The TV/VCR will come on and the screen shown below will appear.

SELECT LANGUAGE

> ENGLISH ON

ESPAÑOL

SELECT KL OR

PRESS MENU TO CONTINUE

2

Press the PLAY/K button or the STOP/L button to select

English or Spanish on-screen displays and menus.

3

Press the MENU button. The screen shown below will appear.

CONNECT ANTENNA OR CABLE

TO TVCR

THEN PRESS B

TO END PRESS EXIT

4

Press the F.FWD/B button to begin automatic channel setup. The TV/VCR will memorize all available channels. When channels are set, CHANNELS ARE SET will appear on the screen briefly. Then the TV/VCR will go to the lowest available channel. If you try to set up channels when there is no antenna or cable connected to the TV/VCR, programming will appear to take place, but eventually a NO TV SIGNALS ... message will appear on the screen. Connect an antenna or cable to the ANT(enna) jack on the TV/VCR, then press the F.FWD/B button again. You may need to follow the steps on page 10 instead.

5

Use the CH(annel) o/p buttons or the Number buttons on the remote control to select a TV/VCR channel. Use the VOL(ume) o/p buttons to adjust the sound.

When you scan channels with the CH(annel) o/p buttons, only the memorized channels will be available. Use the Number but- tons to select non-memorized channels.

EJECT

3			POWER		1
	MENU	STATUS	CLEAR	FM
		/EXIT
	1	2		3
5	4	5		6
	7	8		9
	SLEEP/			ALT.CH
	WAKE UP	0			2
	REC			PAUSE
	/OTR	PLAY		/STILL
	REW		F.FWD
		STOP			4
	CH.			VOL.
		MUTE			5
1	CABLE	COMBI		SMART
	/DBS			PICTURE
		SPEED	MEMORY VCR PLUS+
	F.ADV		SLOW	ENTER
	TRACKING		VAR.SLOW
		INDEX		SKIP
			SEARCH

Helpful Hints

•If you do not see any on-screen dis- plays when you turn on the TV/VCR, check your hookups, then try again. If you still do not see any on-screen displays, follow the steps on pages nine-10 to select a language and set up channels.

•To skip step 2, press the MENU button. All on-screen displays will be in English. To skip step 4, press the STATUS/EXIT button. Automatic Channel setup will not occur, and CHANNELS NOT SET will appear on the screen briefly.

•You cannot set up channels if you are using a Cable Box.

•Line Input mode is channel 00. When you select channel 00, A/V IN will appear on the screen briefly. Press the CH(annel) o/p buttons or the Number buttons to select another channel.