Installation

Connecting to the TV (standard configuration)

Connecting the aerial

To receive TV programmes you have to connect the DVD-recorder to the aerial or the cable network.

1Switch off your TV.

2Remove the aerial cable plug A from your TV, and insert it into the ANTENNA IN K socket at the back of the DVD recorder.

3Insert one end of the supplied aerial cable B into the TV OUT L socket at the back of the DVD recorder and the other end into the aerial input socket at the back of the TV.

The aerial socket of the TV may be labeled ANT IN, RF IN, 75 ohm, etc. Check your TV instructions for details.

Connecting the scart cable

The scart (Euro AV) cable is a the universal connector for picture, sound and control signals with practically no loss of picture or sound quality.

1Plug a scart cable C into the scart socket EXT1 TO

TV-I/ON at the back of the DVD recorder and the scart socket for the DVD recorder at the back of the TV (see TV operating instructions).

Several scart sockets on the TV?

Select the scart socket that is suitable for both video output and for video input.

Selection menu for the scart socket?

On some TVs select 'VCR' as the source for this scart socket. Read your instruction manual for your TV for further information.

ORefer to 'Connecting additional devices' to connect devices like satellite receivers, and videorecorders to the input-/output sockets.

Proceed to 'Initial installation'.

Connection with the aerial cable only

To connect this DVD-Recorder to a TV without external Audio/Video input sockets, you need a modulator. With the modulator the audio/video signal is converted in an UHF-channel. This signal can be received and stored on the TV as a TV-station.

11

Page 16
Image 16
Philips DVDR 725H/05 manual Connecting to the TV standard configuration, Connecting the aerial, Connecting the scart cable