Pioneer CDJ-400 AC power cord, Region Plug type For European type region, Operating Environment

S002_En

D3-4-2-2-4_En

D3-4-2-2-2a_A_En

D8-10-1-2_En

D3-4-2-2-1a_A_En

D8-10-3a_En

D3-4-2-1-7c_A_En

D3-4-2-1-7b_A_En

D3-4-2-1-4_A_En

D3-4-2-1-3_A_En

D3-4-2-1-7a_A_En

Thank you for buying this Pioneer product. Please read through these operating instruc- tions so you will know how to operate your model properly. After you have finished read- ing the instructions, put them away in a safe place for future reference.

In some countries or regions, the shape of the power plug and power outlet may some- times differ from that shown in the explana- tory drawings. However the method of con- necting and operating the unit is the same.

K015 En

WARNING

This equipment is not waterproof. To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture.

WARNING

Before plugging in for the first time, read the following section carefully.

The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e.g., 230V or 120V) written on the rear panel.

WARNING

To prevent a fire hazard, do not place any naked flame sources (such as a lighted candle) on the equipment.

VENTILATION CAUTION

When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 5 cm at rear, and 5 cm at each side).

WARNING

Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product, and to protect it from overheating. To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the

IMPORTANT

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

The lightning flash with arrowhead symbol,	CAUTION:	The exclamation point within an equilateral
within an equilateral triangle, is intended to	TO PREVENT THE RISK OF ELECTRIC	triangle is intended to alert the user to the
alert the user to the presence of uninsulated	SHOCK, DO NOT REMOVE COVER (OR	presence of important operating and
"dangerous voltage" within the product's	BACK). NO USER-SERVICEABLE PARTS	maintenance (servicing) instructions in the
enclosure that may be of sufficient	INSIDE. REFER SERVICING TO QUALIFIED	literature accompanying the appliance.
magnitude to constitute a risk of electric	SERVICE PERSONNEL.

shock to persons.

D3-4-2-1-1_En-A

CAUTION
This product is a class 1 laser product, but this product contains a laser
diode higher than Class 1. To ensure continued safety, do not remove any	CLASS 1
covers or attempt to gain access to the inside of the product.
Refer all servicing to qualified personnel.	LASER PRODUCT
The following caution label appears on your unit.
Location: Inside of the player

D3-4-2-1-8_A_En

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

–Reorient or relocate the receiving antenna.

–Increase the separation between the equipment and receiver.

–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

FEDERAL COMMUNICATIONS COMMISSION DECLARATION OF CONFORMITY

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Product Name:	COMPACT DISC PLAYER
Model Number:	CDJ-400
Responsible Party Name: PIONEER ELECTRONICS SERVICE, INC.
Address:	1925 E. DOMINGUEZ ST. LONG BEACH, CA 90801-1760, U.S.A.
Phone:	1-800-421-1404

AC power cord

The type of cord which can be used depends on the power voltage in each region or coun- try. Please make sure you use the correct cord due to the possibility of fire or other hazard if used incorrectly (see below).

AC power cord and converter plug use

Region	Plug type
For European type region	European two-pin plug
Caution

Do not use this power cord set in Taiwan.

For Taiwan exclusively
Caution	Taiwanese two-pin
For use in Taiwan only.	flat-bladed plug
In other areas, please do not use.

2

equipment on thick carpet or a bed.

Operating Environment

Operating environment temperature and humidity:

+5 ºC – +35 ºC (+41 ºF – +95 ºF); less than 85 %RH (cooling vents not blocked)

Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or strong artificial light)

CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for connections.

If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. If connected to an AC outlet, the cut-off plug can cause severe electrical shock. Make sure it is properly disposed of after removal.

The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time (for example, when on vacation).

CAUTION

The POWER switch on this unit will not completely shut off all power from the AC outlet. Since the power cord serves as the main disconnect device for the unit, you will need to unplug it from the AC outlet to shut down all power. Therefore, make sure the unit has been installed so that the power cord can be easily unplugged from the AC outlet in case of an accident. To avoid fire hazard, the power cord should also be unplugged from the AC outlet when left unused for a long period of time (for example, when on vacation).

When using this product follow the instructions written on the underside of the unit, which concern rated voltage, etc.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement.

Information to User

Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment.

D8-10-2_En

<DRB1452> En