Before You Start
Removing the front panel
1Press and hold EJECT to open the front panel.
2Slide and remove the front panel to- ward you.
Take care not to grip it too tightly or to drop the front panel and protect it from contact with water or other fluids to prevent perma- nent damage.
|
| Section |
|
| 01 |
|
| English |
About the demo mode | ||
This unit features two demonstration modes. One is the reverse mode, the other is the fea- ture demo mode.
Important
The red lead (ACC) of this unit should be con- nected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained.
Reverse mode
If you do not perform an operation within about 30 seconds, screen indications start to reverse, and then continue reversing every 10 seconds. Pressing BAND when power to this unit is turned off while the ignition switch is set to ACC or ON cancels the reverse mode. Press BAND again to start the reverse mode.
3Put the front panel into provided pro- tective case for safe keeping.
Attaching the front panel
1Make sure the inner cover is closed.
2Replace the front panel by clipping it into place.
Feature demo mode
The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON. Pressing DISPLAY during feature demo operation can- cels the feature demo mode. Press DISPLAY again to start the feature demo mode. Remem- ber that if the feature demo continues operat- ing when the car engine is turned off, it may drain battery power. 
En 
11
