Pioneer DRM-6NX manual Rear View, Panel Facilities, Ventilators, Black cover, FUNCTION switches

Panel Facilities

Rear View

Ventilators

Ventilation openings protect the unit from overheating thus must remain clear and uncovered

Black cover

The SCSI ID switch of the internal CD-ROM changer is inside this cover. Note that chang- ing this ID setting may cause a breakdown. Do not remove this cover.

FUNCTION switches

Used to set the operation mode of the internal CD-ROM changer. Turn the power off to the unit before changing the operating mode.

1. SCSI terminator switch for internal CD-ROM changer

It is set to ON (terminator ON) at time of shipment. Set it to OFF (terminator OFF) when other drives are to be connected to the SCSI terminal and set the terminator on the connected drive.

2. RESERVE (for service use only)

Must be set to OFF.

3. Disable magazine eject button

ON: Disables MAGAZINE EJECT button (eject disable)

OFF: Enables MAGAZINE EJECT button (eject enabled)

SCSI connector

A50-pin Centronics connector for connecting external PIONEER CD/DVD-ROM drives (a total of 5 units may be connected)

NOTE:

Ö Do not connect a CD-ROM or DVD-ROM drive other than a Pioneer drive to the SCSI terminal on the rear panel

Ö Do not connect this terminal to a SCSI terminal on a PC as this could cause malfunction or breakdown

“SCSI CONNECTION FOR PIONEER CD-ROM/DVD-ROM DRIVE ONLY. DO NOT CONNECT SCSI CONTROLLER.”

Ö Assign a SCSI ID (between 2 to 6) for all connected drives. SCSI ID 0, 1 and 7 are reserved for the internal CD-ROM changer, hard disk drive and network board. Never assign IDs 0, 1 or 7 to an external drive.

SIGNAL GND terminal

AC IN socket

Connect to a wall outlet. This unit is designed to operate at AC 110 – 240 V 50/60 Hz. (There is no power supply voltage switch asswitchover takes place automatically internally)

The accessory power cord is for use in North America. In order regions, please consult your dealer for information on

Reset button

Press this button to return all settings to their factory defaults

Network connector

Connect to the Ethernet or Token Ring network (RJ-45 connector, 100 Base-TX/10 Base-T)

9

<DRB1239>