Pioneer DVR-630H-S Code programming with the power off, Setting a manual timer recording

Recording 05

4Select ‘Store Program’ to finish.

•Other options in the same menu panel allow you to name the program, and change the recording destination and/or recording mode.

G-Code programming with the power off

You can enter a G-Code programming number when the recorder is in standby.

Note that the recording is always made to the HDD. If you want to record to a DVD disc, you’ll need to switch on the power and use the full G-Code program screen.

HDDDVD

CH

G-CODE +	CLEAR
	CLEAR

ENTER

Important

•You can’t use this feature until you have set up the guide channels. See G-Code CH Setting on page 93.

•You can’t change the recording mode.

•You can’t program daily or weekly timer recordings.

1 Press ’G-Code’.

The front panel display shows the current recording mode and prompts you to enter the G-Code programming number.

Setting a manual timer recording

The timer recording screen you can see all the timer programs already set, clear programs and set up new ones.

CLEAR

CLEAR

ENTER

HOME

MENU

PREV NEXT

TIMER REC

1Press TIMER REC to display the Timer Recording screen.

You can also access the Timer Recording screen from the Home Menu (press HOME MENU, select Timer Recording, then Timer Recording).

This screen shows all the timer programs currently set.

Timer Program View

SAT 26/3 15:00				Tmr Pgms 4/32
	Manhattan Open Tennis			OK
	SAT 26/3 18:00 – 21:00		Pr 10
	World Journey			OK
	SUN 27/3	19:30 – 21:00	Pr 4
	Flower			Until 30/4
	MON – FRI	13:30 – 14:00	Pr 8

New Input

HDD Remain 59h59m(SP)

DVD Remain 1h59m(SP)

2Use the number buttons to enter the number.

•To clear the last digit entered, press CLEAR.

3Press ENTER.

The display shows the timer settings:

Date	Start time End time HDD and Recording
channel	Recording mode.

•If CODE ERROR appears in the display, check that the number is correct and that the guide channel is set (see G-Code CH Setting on page 93), then set the timer recording again.

•If CAN’T SET appears in the display, it means that although you entered a valid number, the program has already finished.

•Each row is for one timer recording program, with the date and time information, channel, recording mode, DVD or HDD and recording status.

•The amount of free space available on the HDD and the currently loaded recordable DVD is shown towards the bottom of the screen.

•In the upper-right corner, the number of timer programs already set is shown next to Tmr Pgms.

•If there are more than five timer programs already

set, press NEXT		to switch page (go back using
the PREV	button).

•You can also delete a timer program before it’s started (before the recorder enters timer recording standby) by highlighting it and pressing CLEAR. See also Deleting a timer program on page 43.

41

En