Pioneer DVR-LX70 manual Transmission Mode Auto, Audio Output Auto, Hdmi Control

The Initial Setup menu		14
Setting	Options	Explanation
Colour	RGB (0–255)	Use if colours are weak and black appears to ‘float’
		on the RGB (16–235)setting.
	RGB (16–235)	Use this setting if colours appear overly rich and the
		black too deep on the RGB (0–255)setting.
	YCbCr 4:2:2	The video signal is output as a YCbCr 4:2:2
		component signal. This is the standard setting for
		HDMI-compatible devices.
	YCbCr 4:4:4	The video signal is output as a YCbCr 4:4:4
		component signal.

•Depending on the connected device some settings may not be available.

•When a DVI device is connected, the YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.

Transmission Mode Auto		Select this setting to output video in the optimum
		transmission mode according to the connected
		device.
	Normal	Select this setting when pictures are not shown
		properly.

If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case, press  OPEN/CLOSE while holding down the  (Stop) button on the front panel to switch the setting.

Audio Output	Auto •	Dolby Digital, MPEG and DTS sources are output as a
		bitstream signal. However, depending on the Audio
		Out setting, number of audio channels, and the HDMI-
		connected device, Linear PCM audio may be output.
	PCM	All audio signals are converted to Linear PCM (except
		DTS).

Bitstream Priority Select if the connected device is compatible with bitstream audio.

This setting is not available when a DVI device is connected.

HDMI Control	On •	Enable the HDMI Control function. Select this option
		when connected to an HDMI Control-compatible
		Pioneer plasma television, AV system (amplifier or AV
		receiver etc.).
	Off	Disable the HDMI Control function. Select this option
		when not connected to an HDMI Control-compatible
		component, or when connected to a component
		manufactured by a company other than Pioneer.

•For more information about HDMI Control, see HDMI Control on page 22.

•This setting is available even if you are not connected to an HDMI device.

•For more information see Troubleshooting on page 127.

117

En