Pioneer DVR-LX70 manual Playing CDs and WMA/MP3 discs, Next Press to skip to previous/next, Track

Playback 06

PREV		NEXT	Press to skip to previous/next
			chapter/title. (During playback
			you can also use the front panel
			CH +/– buttons.)
	ABC	DEF	During playback, enter a title
GHI	JKL	MNO	number then press ENTER to
PQRS	TUV	WXYZ	skip directly to that title.
		CLEAR	Press CLEAR to clear a number
		CLEAR	entry and start again.
		ENTER

BACK CM SKIP (Commercial back/skip) Each press skips backward/forward

progressively up to a maximum of two hours in either direction.

STEP/SLOW Press to start slow-motion playback. Press repeatedly to

change the playback speed. While paused, press to advance a single frame in either direction.

Playing CDs and WMA/MP3 discs

The table below shows the basic playback controls for Audio CDs1, and WMA/MP3 files.

PLAY Press to start playback.

STOP Press to stop playback.

REV SCAN FWD SCAN Press to start scanning. Press again to increase the scanning speed. (There are two scan speeds; the current scan speed is shown on-screen.)

PREV	NEXT Press to skip to previous/next
	track.

Playing Video CD/Super VCDs

The table below shows the basic playback controls for Video CD/Super VCDs.

Some discs feature Playback Control (PBC for short) menus. These discs show PBC in the display when you load them and display

amenu on-screen from where you can select what to watch.2

PLAY Press to start playback. Video CD only: If RESUME is

displayed on-screen, playback starts from the place last stopped.

STOP Press to stop playback.

Video CD only: You can resume playback from the same point by pressing  PLAY. (Press

STOP again to cancel the resume function.)

PAUSE Pauses playback, or restarts

playback when paused.

REV SCAN FWD SCAN Press to start scanning. Press repeatedly to increase the scanning speed.

PAUSE Pauses playback, or restarts		NEXT Press to skip to previous/next
playback when paused.	PREV
		track.
		When a PBC menu is displayed,
		press to display the previous/
		next page. (During playback
		you can also use the front panel
		CH +/– buttons.)

Note

1If you want to play a DTS Audio CD, make sure the recorder is connected to a DTS-compatible amplifier/receiver with a digital connection. Noise will be output through the analog outputs. Also make sure that STEREO is

selected using the AUDIO button (see Switching audio channels on page 61).

2When playing in PBC mode, some playback features, such as search, repeat and programme play are not available. You can play a PBC Video CD/Super VCD in non-PBC mode by starting playback using the Disc Navigator (see Using the Disc Navigator with playback-only discs on page 56).

53

En