Pioneer DVR-LX70 manual Before you start Chapter, What’s in the box

D3-4-2-3-3_En

01Before you start

Chapter 1

Before you start

What’s in the box

Please confirm that the following accessories are in the box when you open it;

•Remote control

•AA/R6P dry cell batteries x 2

•Audio/video cable (red/white/yellow)

•RF antenna cable

•Power cable

•These operating instructions

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

WARNING

Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries.

Using the remote control

Putting the batteries in the remote control

•Insert two AA/R6P batteries into the battery compartment following the indications (,) inside the compartment.

Important

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Don’t mix new and old batteries together.

•Don’t use different kinds of batteries together — although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that

isn’t going to be used for a month or

6more.

Please keep in mind the following when using the remote control:

•Make sure that there are no obstacles between the remote and the remote sensor on the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit’s remote sensor.

•Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit.

•Replace the batteries when you notice a fall off in the operating range of the remote.

•When the batteries run down or you change the batteries, the remote control mode is reset to Recorder 1. See Remote Control Mode on page 118.

•Use within the operating range in front of the remote control sensor on the front panel, as shown.

7 m

En