Pioneer DVR-LX70 manual Front panel displays

Additional information	15
Message	Explanation/Action

•Could not operate the DV camcorder. This recorder was not able to operate the DV camcorder.

• The DV camcorder is not set for	The camcorder is in camera mode. Switch it to
playback. Please select playback mode	playback mode.
on the DV camcorder.

•The printer is not ready or is not This message is displayed when communication

connected. Please check the printer. could not be established with the printer. See the

	Troubleshooting section if you do not know the
	cause.
• Printing has been cancelled	This message is displayed when there is a printer
because ...	error during printing. After checking the printer for
	the cause of the error, either reconnect the printer
	and start the printing job again, or select “Yes” to
	resume printing (select “No” to cancel the print
	job). See also the operating instructions that came
	with your printer for possible causes of print errors.

Front panel displays

The table below shows a list of error messages that you may encounter when using the recorder and an explanation of their meaning.

Message	Explanation/Action
• E01	The HDD may be damaged or broken. Please ask
	your nearest Pioneer-authorized service center or
	your dealer to carry out repairs.
• E02	As the HDD info cannot be properly read, no new
	recordings can be made. Reinitializing the HDD
	(page 104) may result in your being able to make

recording again. Note that reinitializing the HDD will erase all recorded contents, including protected files.

131

En