Basic Operations
Watching TV channels
Unless you set up TV channels that you can watch under the current conditions, you cannot tune in those channels. For the procedure, see “Setting up TV channels” on page 31.
•When watching a digital TV program, you may see emergency alert messages scrolling at the top of the screen. Those messages are broadcasted by TV stations as necessary when in emergency situations.
Plasma Display (right view)
CHANNEL +/– 
07
English
Selecting the antenna
After confirming that the Mode switch on the remote control unit has been set to “TV”, press ANT on the remote control unit to select antenna A or B.
•Make this selection depending on the connections to the antenna input terminals on the Media Receiver (page 21).
Changing channels
To increase the channel number, press CH + on the remote control unit. To decrease the channel number, press CH
•CHANNEL +/– on the Plasma Display operates the same as CH +/– on the remote control unit.
•Press CH RETURN to switch the currently tuned channel to the previously tuned channel.
Press CH RETURN again to restore the currently tuned channel.
Using 0 – 9 and • (dot) on the remote control unit
Select channels directly by pressing buttons 0 to 9. To select subchannels, also use the • (dot) button.
EXAMPLE
•To select channel 5
•To select channel 25
•To select channel 125
•To select subchannel 10.01, press 1, 0, • (dot), 0, then 1.
•To select subchannel 10.001 (for the cable TV), press 1, 0,
• (dot), 0, 0, then 1.
•After entering a channel or subchannel number, you may press CH ENTER to tune in the channel more quickly.
•Each time you change a channel, such a channel banner appears that shows information about the currently selected channel. To clear the channel banner, press DTV INFO. For more information about the channel banner, see “Viewing a channel banner” on page 26.
Channel banner
12:33pm
DTV 2 • 1002.102 A
XXXXXXXXXX
12:30pm — 2:00pm
25
En
