13Useful Remote Control Features
Learning function of the remote control unit
You can operate the connected AV products (AV Receiver, Cable Box, SAT tuner, VCR, DVD, DVD recorder, LD) using the learning function of your remote control unit. This remote control unit has a function that can memorize each remote control code.
2 to 5 cm (0.8 to 2.0 inches)
Presetting manufacture codes
1Slide the Mode switch to match the device to which you want to preset the remote control signal.
2Press EDIT/LEARN and 1 at the same time.
•The LED flashes.
3Press 0 – 9 to enter the manufacture code. See page 63.
•Preset mode is finished once the LED no longer lights up.
Remote control | Remote control of |
(Supplied accessory) | AV product |
Using the learning function
1Slide the Mode switch to match the device whose remote control signal you want to be learned.
2Press EDIT/LEARN and 2 at the same time. •The LED flashes.
3Press a button to be learned.
•The LED lights up.
•For the functions that can be learned, see pages 64 to 68.
•When learning is finished, the LED starts flashing again.
4Press EDIT/LEARN again to exit the Learn mode.
•To exit the Learn mode halfway, press EDIT/LEARN again.
•If the Mode switch selection is changed when in the Learn mode, the Learn mode is cancelled.
•If no operation is performed for more than one minute, the Learn mode is cancelled.
•It takes about 2 seconds to finish code transmission. Do not interrupt it halfway. Wait until the LED flashes again.
•You can reset all learned codes to the factory defaults. When not in
the Learn mode, press and hold TV , and then press | and |
VOL + (RECEIVER section) at the same time.
•To exit the Edit mode halfway, press EDIT/LEARN again.
•If the Mode switch selection is changed when in the Edit mode, the Edit mode is cancelled.
•If no operation is performed for more than one minute, the Edit mode is cancelled.
•When you enter a code not listed, the LED flashes quickly.
•If the table on page 63 does not include your desired manufacturer or the remote control does not work, you can make the memory learn its signal by the Learn mode.
•The initial mode is “000” (PIONEER).
62
En
