Pioneer PRO-1120HD, PRO-920HD Connecting the VCR controller, Screen for recording test appears

Enjoying through External Equipment

12

Connecting the VCR controller

Connect the supplied VCR controller to the Media Receiver. This allows you to preset digital TV programs for recording; see page

48.When the specified time comes, the system in the standby mode is automatically switched on and the specified TV program is recorded using the connected VCR or DVD recorder.

•Make sure to leave the VCR power on when presetting TV programs for recording with the VCR controller.

•Be sure to firmly connect the VCR controller to the VCR control terminal on the rear of the Media Receiver. If you have mistakenly connected it to the CONTROL IN or CONTROL OUT terminal, remote control or other operations may be disabled.

Use the following procedure to set the manufacture of the recording equipment:

1Press HOME MENU.

2Select “Tuner Setup”. (/ then ENTER)

3Select “Recorder Setup”. (/ then ENTER)

4Select “VCR Setup”. (/ then ENTER)

5Select the manufacture of the recording equipment. (/ then ENTER)

Recorder Setup	VCR Setup
VCR Setup		xxxxxxxxxxxxxxxxxxxxx
	• XXXXX	xxxxxxxxxxxxxxxxxxxxx
	XXXXX	xxxxxxxxxxxxxxxxxxxxx
	XXXXX
		Home Menu Exit

English

Media Receiver (rear view)

• The screen for recording test appears.

I N	OUT	VCR CONTROL
CONTROL		IN
	ANTENNA B
		S-VIDEO
SERVICE ONLY
		OUT
		MONITOR OUT S-VIDEO

DIGITAL O

OPTICA

ANTENNA/	Cable
CABLE A IN	CARD
		(TS)	S400
INPUT 2			INPUT 1	COMPON
VIDEO	R-AUDIO-L	VIDEO	R-AUDIO-L	Y	CB/
VIDEO	R-AUDIO-L	S-VIDEO	R-AUDIO-L IINPUT 33	Y	CB/

(Once you have positioned the VCR controller, secure with the supplied tape.)

6 Check that the power to the recording equipment is on,

and insert tape into the slot.

• Insert tape you think it all right to erase its contents.

The contents will be erased because Rec and Stop

codes are output in the test.

• Check that the light emitting section on the VCR

controller cable faces the recording equipment.

7 Press A to execute recording test.

• If the recording equipment fails to start and stop

recording, check and change the specified recording

equipment manufacture.

VCR CONTROL

VCR or DVD recorder

Position the light emitting section on the VCR controller cable so that it faces the VCR.

Remote control sensor

8	Press A to select “Yes, Store Setting”.
9	Press HOME MENU to exit the menu.

.

•Even if you correctly specify the manufacture of the recording equipment, control of some models may be disabled.

•Perform the recording test when the recording equipment is not in recording standby or is not recording.

•The recording test takes approximately 10 seconds.

•The PIONEER has been set as the factory default.

59

En