Pioneer VSX-59TXi operating instructions Other connections, Select ‘PC Output’ and press ENTER

Other connections 10

1 Select ‘PC Output’ and press ENTER.

When the receiver is ready for transmission, Operate a

PC shows on the OSD.

2.4. Acoustic Cal EQ				Pro.	2.4. Acoustic Cal EQ Pro.
		Manual		Pro.
[ Reverb		Measurement ]				Operate a PC
[ Reverb		View ]
_[			]
	PC	Output
[ Advanced EQ Setup ]
[Return]					[		]
						Return

•If PC Output isn’t displayed, the receiver probably doesn’t have any transmission data. Make sure you have completed steps 1–6 in Using Professional Acoustic Calibration EQ on page 64.

2Connect your computer to the RS-232C jack on the rear panel of the receiver.

Use a commercially-available cable to connect the RS- 232C jack on your computer to the 9-pin RS-232C jack on this receiver. See the documentation provided with the Advanced MCACC application for more information.

RS-232C

PC

3Start the MCACC application on your computer. Follow the instructions provided with the application. It will take about ten seconds for the transmission to complete, then you will be able to analyze the output on your computer. Since the data will be cleared from the receiver when you restart reverb measurement or turn off the receiver, you might want to save the information on your PC after measurement.

4When you’re finished, select ‘Return’ on the on- screen display.

You’ll be taken to the Advanced EQ Setup. Depending on the results, you may want to continue with the Advanced EQ setup (see Setting Professional Acoustic Calibration EQ according to your room characteristics on page 63 for more on this). You can also simply press Return again to exit the Professional Acoustic Calibration EQ setup.

89

En