Using other functions
Note
•If you change the source using the input buttons (or front panel INPUT SELECTOR dial), the system returns to normal playback.
Enhancing SACD playback
You can get more detail from SACDs by maximizing the dynamic range (during digital processing) using the SACD gain feature.
1Press OPTION repeatedly until SACD GAIN shows in the display.
With the remote, you may need to press RECEIVER on the
Home menu ( ) first before reaching the receiver menu
screen shown below (use the (cursor left/right) soft keys to go to the previous/next menu screen).
|
|
|
|
| Receiver |
|
|
|
|
| |
|
|
|
| MIDNIGHT | DIGITAL NR |
|
|
| |||
|
|
|
| TONE | LOUDNESS |
|
|
| |||
|
|
|
| OPTION |
| + | – |
|
|
| |
|
|
|
| CH LEVEL |
| + | – |
|
|
| |
ACOUSTIC |
|
|
|
|
|
|
| TUNER | SBCH | MULTI ROOM & SOURCE | |
CAL. | MIDNIGHT | TONE | OPTION |
|
| DIGITALNR | CLASS | STATION | MODE | CONTROL | ON/OFF |
PHONES | SPSYSTEM | SIGNAL | VIDEO | TAPE2 | STREAM | SETUP |
| VIDEOINPUT |
|
| |
|
|
|
|
| |||||||
| A/B | SELECT | SELECT | MONITOR | DIRECT | MIC | DIGITALIN |
|
|
|
|
|
|
|
|
|
|
|
| VIDEO | L AUDIO | R |
2Use the (OPTION) +/– buttons to switch the SACD gain between 0dB and 6dB.
For most SACD sources, selecting 6dB will result in high sound quality and greater detail. The level will be adjusted automatically for playback at the same volume.
3Press ENTER to confirm.
Note
•You shouldn’t have any problems using this feature with most SACD discs, but if the sound distorts, it is best to switch the gain setting back to 0dB.
09
Using the A/D converters to give greater definition to
This receiver has
1Switch the SD:1 NORMAL Stream Direct mode
on.
See Using the Stream Direct mode on page 47 for more on this.
2Select the STEREO listening mode and switch off any other sound processing features.
These features include:
•Midnight/Loudness (page 52)
•Digital Noise Reduction (page 53)
•Dynamic Range Control (page 94)
Also, make sure you also switch the multichannel input to 2 CHANNEL in Selecting USB and multichannel analog input channels on page 49.
Dimming the display
You can choose between four brightness for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds.
•From the remote control receiver menu, press DISPLAY DIMMER repeatedly to change the brightness of the front panel display.
You may need to press RECEIVER on the Home menu ( ) first before reaching the receiver menu screen shown
below (use the (cursor left/right) soft keys to go to the previous/next menu screen).
RECEIVER 3/4
TV
RECEIVER CONT
INPUT | SB CH |
MODE | |
SPEAKER | INPUT |
A/B | ATT |
VIDEO | DISPLAY |
SELECT | DIMMER |
TAPE2 | STATUS |
MONITOR |
77
En