Pioneer VSX-919AH-K manual Video, Settings

12Additional information

Video

Symptom	Remedy
No image is output when an	• Check the video connections of the source component (see page 28).
input is selected.	• For HDMI, or when digital video conversion is set to OFF and a TV and another
	component are connected with different cords (in Setting the Video options on
	page 67), you must connect your TV to this receiver using the same type of video
	cable as you used to connect your video component.
	• Make sure the input assignment is correct for components connected using
	component video or HDMI cables (see The Input Setup menu on page 39).
	• Check the video output settings of the source component.
	• Check that the video input you selected on your TV is correct.
	• Some components (such as video game units) have resolutions that may not
	be converted. If adjusting this receiver’s Resolution setting (in Setting the Video
	options on page 67) and/or the resolution settings on your component or
	display doesn’t work, try switching Digital Video Conversion (in Setting the Video
	options on page 67) OFF.
Can’t record video.	• Check that the source is not copy-protected.
	• The video converter is not available when making recordings. Check that the
	same type of video cable is used for connecting both the recorder and the video
	source (the one you want to record) to this receiver.
Noisy, intermittent, or	• Sometimes a video deck may output a noisy video signal (during scanning,
distorted picture.	for example), or the video quality may just be poor (with some video game units,
	for example). The picture quality may also depend on the settings, etc. of your
	display device. Switch off the video converter and reconnect the source and
	display device using the same type of connection (component or composite),
	then start playback again.

Settings

Symptom	Remedy
The Auto MCACC Setup	• The ambient noise level may be too high. Keep the noise level in the room as
continually shows an error.	low as possible (see also Problems when using the Auto MCACC Setup on
	page 39). If the noise level cannot be kept low enough, you will have to set up
	the surround sound manually (page 94).
	• When using only one surround back speaker, connect it to the SURROUND
	BACK L (Single) terminals.
	• To use a 5.1-channel speaker set, use the surround speakers for the surround
	channel, not the surround back channel.
	• Make sure there are no obstacles between the speakers and the microphone.
	• If Reverse Phase is displayed, try the following:
	– The speaker’s wiring (+ and –) may be inverted. Check the speaker
	connections.
	– Depending on the type of speakers and their installation conditions, Reverse
	Phase may be displayed even if the speakers are properly connected. If this
	happens, select GO NEXT and continue.
	– If the speaker is not pointed to the microphone (listening position) or when
	using speakers that affect the phase (dipole speakers, reflective speakers, etc.),
	it may not be possible to properly identify the polarity.

106

En