Pioneer VSX-919AH-K manual Remote control

Additional information 12

Remote control

SymptomRemedy

Cannot be remote controlled. • Set a 5-digit preset code corresponding to the receiver to be operated in the remote control (see Operating multiple receivers on page 73).

•Check whether the receiver’s remote control mode is properly set (see Remote Control Mode Setup on page 101).

•Try replacing the batteries in the remote control (see Loading the batteries on page 7).

•Be sure to operate within 7 m (23 feet) and a 30º angle of the remote sensor on the front panel (see Operating range of remote control unit on page 13).

•Check that there are no obstacles between the receiver and the remote control.

•Make sure that there is no fluorescent or other strong light shining on to the remote sensor.

•Check the connections of the CONTROL IN jack (see Operating other Pioneer components with this unit’s sensor on page 32).

Other components can’t be	• If the battery ran down, the preset codes may have been cleared. Re-enter the
operated with the system	preset codes.
remote.	• The preset code may be incorrect. Redo the procedure for entering preset
	codes.

HDMI

Symptom	Remedy
The HDMI indicator blinks	• Check all the points below.
continuously.
No picture or sound.	• This receiver is HDCP-compatible. Check that the components you are
	connecting are also HDCP-compatible. If they are not, please connect them
	using the component or composite video jacks.
	• Depending on the connected source component, it’s possible that it will not
	work with this receiver (even if it is HDCP-compatible). In this case, connect
	using the component or composite video jacks between source and receiver.
	• If the problem still persists when connecting your HDMI component directly
	to your monitor, please consult the component or monitor manual or contact
	the manufacturer for support.
	• If video images do not appear on your TV or flat panel TV, try adjusting the
	resolution, DeepColor or other setting for your component.
	• If ‘NOT SUPPORT’ appears in the receiver’s display, try adjusting the
	resolution, DeepColor or other setting for your component.
	• While analog video signals are being output over HDMI, use a separate
	connection for audio output.
	• When this receiver reproduces MULTI CH IN audio sources with the HDMI
	setting set to THROUGH, you cannot hear audio output from all channels. In
	this case, make a digital or analog audio connection.
	• To output signals in DeepColor, use an HDMI cable (High Speed HDMI™
	Cable) to connect this receiver to a component or TV with the DeepColor
	feature.
No picture.	• Try changing the Resolution setting (in Setting the Video options on page 67).

109

En