Pioneer VSX-919AH-K manual Select ‘Fine SP Distance’ from the Manual Mcacc setup menu

10The Advanced MCACC menu

1Select ‘Fine SP Distance’ from the Manual MCACC setup menu.

1c.Manual MCACC

A/V RECEIVER

1.Fine Channel Level

2.Fine SP Distance

3.Standing Wave

4.EQ Adjust

5.EQ Professional

	1c2.Fine SP Distance
		A/V RECEIVER
	MCACC : M1.MEMORY 1
Exit	Reference Ch :	L	Return
	Ref.Ch Distance :	10’00”
	Exit		Cancel

2Adjust the distance of the left channel from the listening position.

3Select each channel in turn and adjust the

distance as necessary.

Use / to adjust the delay of the speaker you selected to match the reference speaker. The delay is measured in terms of speaker distance from 0’00-1/2’’to 45’00’’.

When it sounds like the delay settings are matched up, press  to confirm and continue to the next channel.

•For comparison purposes, the reference speaker will change depending on which speaker you select.

•If you want to go back and adjust a channel, simply use / to select it.

4When you’re finished, press RETURN. You will return to the Manual MCACC setup menu.

		1c2.Fine SP Distance
		A/V RECEIVER
	R <=> L
L	:	10’10”
R	:	9’10”
C	:	10’10”
SL	:	9’00”
SR	:	9’00”
SBL	:	6’00”
SBR	:	6’00”
SW	:	12’10”
Exit		Finish

Listen to the reference speaker and use it to measure the target channel. From the listening position, face the two speakers with your arms outstretched pointing at each speaker. Try to make the two tones sound as if they are arriving simultaneously at a position slightly in front of you and between your arm span.1

Note

1 • If you can’t seem to achieve this by adjusting the distance setting, you may need to change the angle of your speakers very slightly.

•For better audibility, the subwoofer emits a continuous test tone (oscillating pulses are heard from your other speakers). Note that it may be difficult to compare this tone with the other speakers in your setup (depending on the low frequency response of the reference speaker).

84

En