Printer does not print
·Check if the network cable is correctly connected. If needed, change the cable and try again.
·If the printer is on, turn the printer off and then on again.
·Check that Fast EtherNet has connected to the file server.
·Has the printer driver been maped to the correct netware queue?
A PostScript Error Occurs If a Banner Page is Printed
·A PostScript banner page cannot be printed in the NetWare3.12 remote printer mode. If a PostScript printer is used, therefore, and a banner page is printed, “PostScript error” is displayed. Make sure to turn the banner output “Off” in the client’s printing settings.
Trouble while using EtherTalk
Not identified by the Chooser and the Setup Utility
·If the printer is on, turn the printer off and then on again.
·Check if the network cable is correctly connected. If needed, change the cable and try again.
·In the case of a network residing in a zone, check if the correct zone name (the zone connected to the printer) is selected in the chooser. In addition, check if the zone name in the utility related to the Fast EtherNet is identical to the zone name set in the Fast EtherNet.
·Check if the “AppleTalk”, displayed at the right bottom of the chooser, is “Enabled”.
·Check if “Ethernet” is selected in the “AppleTalk” of the control panel. In some OS versions there is no “AppleTalk” but “Network”. In such a case, check if “EtherTalk” is selected.
·Check if the print driver that responded to the printer onto which the Fast EtherNet is attached, is selected in the chooser.
·The EtherTalk protocol of the Fast EtherNet may have become disabled. In such a case, change it to “Enable” in the utility related to the Fast EtherNet.
·Print the content of the Fast EtherNet settings and confirm that the “EtherTalk port name” did not become blank.
·Turn the printer off, switch DIP switch [2] on and turn the printer on again, initialize the Fast EtherNet and reset the printer driver.
148 | Fast Ethernet 7100e+ |
