Pioneer VSX-919AH-K Saving station presets, Naming station presets, Listening to station presets

05Basic playback

3Press D.ACCESS (Direct Access).

4Use the number buttons to enter the frequency of the radio station.

For example, to tune to 106.00 (FM), press 1, 0, 6, 0, 0.

If you make a mistake halfway through, press D.ACCESS twice to cancel the frequency and start over.

Saving station presets

If you often listen to a particular radio station, it’s convenient to have the receiver store the frequency for easy recall whenever you want to listen to that station. This saves the effort of manually tuning in each time. This receiver can memorize up to 63 stations, stored in seven banks, or classes (A to G) of 9 stations each. When saving an FM frequency, the MPX setting (see page 51) is also stored.

1Tune to a station you want to memorize. See Listening to the radio on page 51 for more on this.

2Press T.EDIT (TUNER EDIT).

The display shows PRESET MEMORY, then a blinking memory class.

3Press CLASS to select one of the seven classes, then press PRESET /to select the station preset you want.

You can also use the number buttons to select a station preset.

4Press ENTER.

After pressing ENTER, the preset class and number stop blinking and the receiver stores the station.

Naming station presets

For easier identification, you can name your station presets.

1Choose the station preset you want to name.

See Listening to station presets below for how to do this.

52

2 Press T.EDIT (TUNER EDIT).

The display shows PRESET NAME, then a blinking cursor at the first character position.

3 Input the name you want.

Choose from the following characters for a name up to eight characters long.

ABCDEFGHIJKLMNOPQRSTUVWXYZ

abcdefghijklmnopqrstuvwxyz

0123456789

!”#$%&’()∗+,–./:;<=>?@[ \ ]^_{} ˜ [space]

Use /to select a character, /to set the position, and ENTER to confirm your selection.

Tip

•To erase a station name, simply repeat steps 1 to 3 and input eight spaces instead of a name.

•Once you have named a station preset, you can press DISP when listening to a station to switch the display between name and frequency.

Listening to station presets

You will need to have some presets stored to do this. See Saving station presets above if you haven’t done this already.

1Press TUNER to select the tuner.

2Press CLASS to select the class in which the station is stored.

Press repeatedly to cycle through classes A to G.

3Press PRESET / to select the station preset you want.

•You can also use the number buttons on the remote control to recall the station preset.

En