Pioneer VSX-AX5Ai-G, VSX-AX5Ai-S manual Using multi operations, Press Multi Operation

08Controlling other equipment

4 Use (cursor up/down) to select a command in the sequence then press ENTER.

If this is the first command in the sequence, select 1st Cmmnd. Otherwise, simply choose the next command in the sequence.

5To add (or change) a command select ‘Change’ and press ENTER.

Function flashes in the display.

•To erase a command select Clear and press ENTER. You will return to the last step.

•To go back a step, select *Exit* and press ENTER.

6Press the MULTI CONTROL button for the

component whose command you want to input. Key flashes in the display.

7Select the button for the command you want to input.

The following remote control commands can be selected:

SOURCE TV

DIMMER	LOUDNESS	TONE	EFFECT/CHSEL
1	2	3	4
SIGNAL SEL	DNR	BASS/TREBLE	+
5	6	7	8
VIDEO SEL	HI-BIT	+10	DISC
9	0		ENTER
SYSTEM SETUP		DIRECTACCESS SEARCHMODE
			GUIDE
MENU			TOPMENU
TUNER EDIT			TRACK
	ENTER
			EXIT
AUDIO			RETURN
MPX	TEXTON RFATT		DISPMODE
			SUBTITLE
TUNING	BAND		TUNING +
STATION	TEXTOFF CLASS		STATION +
CHANNEL			CHANNEL+
+	TV INPUT
	TVCONTROL
TV VOL	+	MIDNIGHT
	TV CH
		MULTI DH
		INPUT
STEREO/		SB CH
DIRECT		MODE

•After selecting a command, COMPLETE appears in the display.

8Repeat steps 4–7 to program a sequence of up to five commands.

•You don't need to program the receiver to switch on or off. This is done automatically.

With Pioneer components, you don’t need to:

•program the power to switch off in a shutdown sequence;

•program the power to switch on if it’s the source component selected in step 3;

•program a Pioneer TV or monitor to switch on if the input function (selected in step 2) has video input terminals;

These take priority in multi operations (not shutdown).

9 When you’re finished, use (cursor up/down) to select ‘*Exit*’ from the menu and press ENTER. You will return to the REMOTE SETUP menu. Select *Exit* again to exit.

Using multi operations

You can start multi operations with the receiver switched on, or in standby.

DVD/LD	TV/SAT	VCR1 /	TVCONT
		DVR
MULTI CONTROL
VCR2	VIDEO	CD	MULTI
			OPERATION
CD-R/	MD/	TUNER
TAPE1	TAPE2

1 Press MULTI OPERATION.

Select Function flashes in the display.

2Press a function button that has been set up with a multi operation.

The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically.

64

En