Pioneer VSX-AX5Ai-G, VSX-AX5Ai-S manual 09Using other functions, Switching the speaker impedance

09Using other functions

2Press DIMMER repeatedly to change the brightness of the front panel display.

Tip

•Switching the dimmer to lowest setting will also switch off the MCACC and i.LINK indicators.

Switching the speaker impedance

• Default setting: Speaker 8Ω

You can use speakers with a nominal impedance between 6–16Ωbut if you are using speakers with an impedance of less than 8Ω, you must change the impedance setting below.

• With the receiver in standby, press STANDBY/ ON while holding down the SPEAKERS button.

Advanced remote control features

Note

•You can cancel or exit any of the following steps by pressing REMOTE SETUP.

•After one minute of inactivity, the remote goes to sleep. Press any button to reactivate the remote display and continue.

DVD/LD	TV/SAT	VCR1 /	TVCONT
		DVR
MULTI CONTROL
VCR2	VIDEO	CD
CD-R/	MD/	TUNER
TAPE1	TAPE2

REMOTE

SETUP

ENTER

	Editing remote control display names
	You can rename what appears in the display on the
	remote control for the MULTI CONTROL buttons (such
	as DVD/LD or TV/SAT), or for individual buttons for each
	input source. You may want to do this if the component
	connected to the inputs doesn’t correspond to the
	MULTI CONTROL button name, or individual commands
	don’t correspond to their respective buttons.
	1 Press and hold REMOTE SETUP for three seconds.
Each time you do this, you switch between the
	The REMOTE SETUP menu appears in the remote control
impedance settings:	display.
• Speaker 6Ω – Use this setting if your speakers are	2 Use	(cursor up/down) to select ‘FuncName’
rated lower than 8Ω (down to 6Ω).
	or ‘Key Label’ from the menu and press ENTER.
• Speaker 8Ω – Use this setting if your speakers are
	Select Function Name (FuncName) if you want to rename
rated 8Ω–16Ω.	a MULTI CONTROL button.

Select Key Label (KeyLabel) if you want to rename a command button (you can rename individual command buttons for each input source).

Select Function flashes in the display.

3 Press the MULTI CONTROL button for the component.

If you selected Function Name (FuncName) above, go to step 5.

If you selected Key Label (KeyLabel) above, Select Key flashes in the display.

68

En