Initial Set Up
ë |
| USE | SETUP | |
S0URCE |
|
| RECEIVER | |
| MULTI | SYSTEM |
| |
| OPERATION | OFF |
| |
DVD/LD | TV/SAT | VCR1 | VCR2 | |
| MULTI CONTROL |
| ||
CD | MD/ | TUNER | TVCONT | |
TAPE1 | ||||
|
|
| ||
CLASS | MPX | BAND | DIRECT ACCESS | |
¦ | 7 | 3 | 8 | |
- TUNING + | - STATION + | |||
1 Á 4 ¢ | ||||
DTV ON/OFF | DTV MENU | - CHANNEL + | ||
1 | 2 |
| 3 | |
4 | 5 |
| 6 | |
7 | 8 |
| 9 | |
GUIDE | 0 |
| EXIT | |
|
| ENTER | ||
+10 |
|
| DISC | |
4Adjust speaker levels so that you hear the test tone at the same volume from each speaker when seated in your main listening
position.
Note: The volume of the subwoofer tends to sound lower than it actually is, you may need to raise its level after testing the sound with actual soundtracks.
In AUTO mode
1Press the 2 or 3 button to adjust the level of the speaker outputting the TEST TONE.
In MANUAL mode
1Press the 2 or 3 button to adjust the level of the first speaker.
2Press the 5/° button to switch the TEST TONE to the next speaker.
3Repeat 1 and 2 for each speaker.
+ | TV |
| + |
| If you are using a Sound Pressure Level (SPL) meter |
TV VOL | TV FUNC |
| VOLUME |
| Take the readings from your main listening position and adjust |
TV CONTROL |
|
|
| ||
– |
|
| – |
| the level of each speaker to 75 dB SPL |
|
|
|
|
| |
INPUT | MENU |
| MUTE |
| mode). |
REMOTE SETUP |
|
|
|
|
|
ATT |
|
|
|
|
|
SYSTEM SETUP |
|
|
|
|
|
EFFECT/ | + |
| FUNCTION |
|
|
CH SEL |
|
| When you have adjusted each speaker level, | ||
| ENTER |
|
| ||
DIGITAL | – |
| SIGNAL |
| press ENTER button to return to the |
NR |
| SELECT |
|
| |
MIDNIGHT | MULTI CH | DSP | STEREO/ |
| previous screen. |
LIGHT | INPUT |
| DIRECT |
| |
ADVANCED | STANDARD |
| |||
|
|
| /DTS |
|
|
|
|
|
|
| The MASTER VOLUME will return to its original position. |
AV PREREMOTE- CONTROL UNIT |
| 6 | Select EXIT with the 5/° buttons and press | ||
PROGRAMMED AND LEARNING |
|
| |||
ENTER button to return to the SYSTEM
SETUP MENU.
memo
Note that it is also possible to set channel levels temporarily. Then follow the same procedure as explained on this page. This function is designed to be used when you want to change the levels temporarily to raise the level of one channel. Using this method you can set speaker levels in different modes, such as, STEREO, and each DSP mode, independently. You should return the settings to their original state when done. Doing the set up procedures on this page will erase any temporary/independent level settings that have been made.
Next, proceed to CROSSOVER NETWORK on the next page.
If you want to change a setting before proceeding simply use the arrow buttons to go back.
36
