Initial Set Up
Multi Channel In Setting
If you have a Multi Channel external decoder you can choose whether to have the sound level set to BYPASS, in which case only the main volume can be controlled, or to ADJUST, which means the levels can be reduced in volume. If continuing from Dynamic Range Control go to step 1. If starting fresh, complete steps
ë |
| USE | SETUP |
S0URCE |
|
| RECEIVER |
| MULTI | SYSTEM |
|
| OPERATION | OFF |
|
DVD/LD | TV/SAT | VCR1 | VCR2 |
| MULTI CONTROL |
| |
CD | MD/ | TUNER | TVCONT |
TAPE1 | |||
CLASS | MPX | BAND | DIRECT ACCESS |
¦ | 7 | 3 | 8 |
- TUNING + | - STATION + | ||
1 Á 4 ¢ | |||
DTV ON/OFF | DTV MENU | - CHANNEL + | |
1 | 2 |
| 3 |
4 | 5 |
| 6 |
7 | 8 |
| 9 |
GUIDE | 0 |
| EXIT |
|
| ENTER | |
+10 |
|
| DISC |
+ | TV |
| + |
TV VOL | TV CONTROL |
| VOLUME |
– | TV FUNC | – | |
REMOTE SETUP
1 Use the 5´° buttons to select MULTI
CHANNEL IN.
See “Setting Up for Surround Sound“ on page 29 if you need more information.
Press the ENTER button.
This information will be displayed on your TV.
Multi channel in Select mode [Channel Level]
[BYPASS]
[EXIT]
INPUT | MENU | MUTE |
ATT | ||
SYSTEM SETUP |
|
|
EFFECT/ | + | FUNCTION |
CH SEL |
|
| ENTER |
| 2 Use the 2´3 buttons to select the setting | |
NR | – | SELECT |
| |
DIGITAL |
| SIGNAL |
| you want, BYPASS or ADJUST. |
| INPUT | DIRECT |
| |
MIDNIGHT | MULTI CH DSP | STEREO/ |
|
|
|
| /DTS |
|
|
LIGHT | ADVANCED | STANDARD |
|
|
ADJUST: Use the ADJUST setting when you want to be able to control each channel level individually.
AV
REMOTE CONTROL UNIT
BYPASS: This setting is good for getting the cleanest possible signal. In this setting you won’t be able to change each channel individually.
We recommend using BYPASS and the default setting is
BYPASS.
3 Use the 5´° buttons to select EXIT.
Press the ENTER button.
You will return to the SYSTEM SETUP mode.
Multi Channel In Setting Using the Main Unit
You can also use the main unit to change the sound level of the MULTI CH IN. Follow the steps below.
STANDBY/ON | MULTI CH INPUT |
DOWN | UP |
40
1Put receiver in the STANDBY mode.
2While holding down the MULTI CH
INPUT button press the
STANDBY/ON button.
The setting will change depending on what state the receiver was previously in. For a few seconds the display will show you which MULTI CH setting you are now in.
memo The default setting is BYPASS.
