Pioneer VSX-D909S manual Bass Peak Level, be selected

Initial Set Up

Bass Peak Level

The LFE (Low Frequency Effect) channel in Dolby Digital or DTS program sources can produce heavy ultra-low bass tones that may exceed the capabilities of your speaker system. The following steps show you how to set a maximum output level for the LFE channel. If continuing from Crossover Network go to step 1. If starting fresh, complete steps 1-3 in "Setting Up for Surround Sound" (p.29) first.

ë￿		USE	SETUP
S0URCE			RECEIVER
	MULTI	SYSTEM
	OPERATION	OFF
DVD/LD	TV/SAT	VCR1	VCR2
	MULTI CONTROL
CD	MD/	TUNER	TVCONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS
¦￿	7	3	8
- TUNING +		- STATION +
1 Á￿		4 ¢
DTV ON/OFF	DTV MENU	- CHANNEL +
1	2		3
4	5		6
7	8		9
GUIDE	0		EXIT
			ENTER
+10			DISC
+	TV		+
TV VOL	TV CONTROL		VOLUME
–	TV FUNC		–
REMOTE SETUP
INPUT	MENU		MUTE
ATT
SYSTEM SETUP
EFFECT/	+		FUNCTION
CH SEL

ENTER 1-3

DIGITAL	–		SIGNAL
NR			SELECT
MIDNIGHT	MULTI CH	DSP	STEREO/
	INPUT		DIRECT
			/DTS
LIGHT		ADVANCED	STANDARD

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

VSX-D909SDigital Signal Processor

DOWN UP

MASTER VOLUME

memo

If you select SETTING CANCEL no settings are input to the receiver but the screen remains on the TV. To escape the screen you must Select EXIT and press the ENTER button.

1Select BASS PEAK LEVEL (if continuing from CROSSOVER NETWORK it will already

be selected).

See “Setting Up for Surround Sound“ on page 29 if you are unsure how to do this.

Press the ENTER button.

Bass Peak Level Manager

[Setting Start ]

[Setting Cancel]

[EXIT]

2Output the test tone for the LFE channel and specify the peak level.

1 If your subwoofer has a volume control, set it to the middle position before proceeding.

2Select SETTING START.

3Press the ENTER button.

Bass Peak Manager

[Setting OK ]

Bass Peak Level [– 50]

[EXIT]

MASTER VOLUME rotates to MIN (---dB). Then the test tone is output to the subwoofer or front or surround speakers.

4Use the 2 or 3 button arrows to gradually increase the level of the LFE channel until the test tone begins to distort. Then go back and leave the level setting at a point just before that. Press the ENTER button and the receiver will remember this bass output level.

To exit before outputting the TEST TONE select EXIT and press the ENTER button.

To exit while outputting the TEST TONE press the ENTER button.

3 Select EXIT and press the ENTER button to return to the SYSTEM SETUP MENU.

This completes the speaker setup.

38