Pioneer VSX-LX60 operating instructions Video, Settings, Additional information, Symptom, Remedy

Additional information 14

Video

Symptom	Remedy
No image is output when an input	• Check the video connections of the source component (see page 16).
is selected.	• For high-definition video (using component video connections), or when digital video conversion is
	switched off (in Setting the Video options on page 71), you must connect your TV to this receiver using the
	same type of video cable as you used to connect your video component.
	• Make sure the input assignment is correct for components connected using component video, HDMI or
	S-video cables (see The Input Setup menu on page 66).
	• Check the video output settings of the source component.
	• Check that the video input you selected on your TV is correct.
	• Some components (such as video game units) have resolutions that may not be converted. If adjusting
	this receiver’s Resolution setting (in Setting the Video options on page 71) and/or the resolution settings on
	your component or display doesn’t work, try switching Digital Video Conversion (in Setting the Video options
	on page 71) OFF.
Can’t record video.	• Check that the source is not copy-protected.
	• The video converter is not available when making recordings. Check that the same type of video cable is
	used for connecting both the recorder and the video source (the one you want to record) to this receiver.
Noisy, intermittent, or distorted	• Sometimes a video deck may output a noisy video signal (during scanning, for example), or the video
picture.	quality may just be poor (with some video game units, for example). The picture quality may also depend on
	the settings, etc. of your display device. Switch off the video converter and reconnect the source and display
	device using the same type of connection (component, S-video or composite), then start playback again.

Settings

Symptom	Remedy
The Auto MCACC Setup	• The ambient noise level may be too high. Keep the noise level in the room as low as possible (see also
continually shows an error.	Problems when using the Auto MCACC Setup on page 9). If the noise level cannot be kept low enough, you
	will have to set up the surround sound manually (page 50).
After using the Auto MCACC	• There may have been some low frequency noise in the room from an air-conditioner, motor, etc. Switch off
Setup, the speaker size setting is	all other appliances in the room and use Auto MCACC Setup again.
incorrect.	• Depending on a number of factors (room size, speaker placement, etc.) this may occur in some cases.
	Change the speaker setting manually in Speaker Setting on page 50, and use the ALL (Keep SP SYSTEM)
	option for the Custom Menu in Automatic MCACC (Expert) on page 39 if this is a recurring problem.
Can’t adjust the Fine Speaker	• Check that the speakers are all in phase (make sure the positive (+) and negative (–) terminals are
Distance setting (page 44)	matched up properly).
properly.
The display shows KEY LOCK	• With the receiver in standby, press  STANDBY/ON while holding down the SPEAKERS button to
ON when you try to make	disable the key lock.
settings.
Most recent settings have been	• The power cord was disconnected from the wall while adjusting this setting.
erased.

85

En