08Other connections
1 Connect the front, surround, center and subwoofer
outputs on your DVD player to the corresponding Speaker B setup MULTI CH input jack on this receiver.
•Use standard RCA/phono jack cables for the connections.
2If your DVD player also has outputs for surround back channels, connect these to the corresponding MULTI CH input jacks on this receiver.
•Use standard RCA/phono jack cables for the connections.
•If there is a single surround back output, connect it to the SURROUND BACK L (Single) jack on this receiver.
Selecting the multichannel analog inputs
If you have connected a decoder or a DVD player as above, you must select the analog multichannel inputs
for surround sound playback.1
RECEIVER INPUT | SYSTEM OFF |
SOURCE | |
SELECT |
|
CD |
| HDMI | |
DVD | TV | BD | TVCTRL |
HOME MEDIA
1Make sure you have set the playback source to the proper output setting.
For example, you might need to set your DVD player to output multichannel analog audio.
2Use the INPUT SELECT button to select MULTI CH
IN.
You can also use the INPUT SELECTOR dial on the front panel.
•Depending on the DVD player you’re using, the analog output level of the subwoofer channel may be too low. In this case, the output level of the subwoofer can be increased by 10 dB in the Multi Ch In Setup in Other Setup. For details, see Multi Channel Input Setup on page 66.
Caution
•Before making or changing the connections, switch off the power and disconnect the power cord from the power outlet. Plugging in components should be the last connection you make with your system.
•Be careful not to allow any contact between speaker wires from different terminals.
•You can use speakers with a nominal impedance between 6 Ω to 16 Ω (please see Switching the speaker impedance on page 71 if you plan to use speakers with an impedance of less than 8 Ω).
After selecting Speaker B in Surround back speaker setting on page 40, you can use the speakers connected to the (surround back) B speaker terminals on the rear panel to listen to stereo playback in another room. See Switching the speaker system below for the listening options with this setup.
1Connect a pair of speakers to the surround back speaker terminals on the rear panel.
Connect them the same way you connected your speakers in Installing your speaker system on page 19. Make sure to review Placing the speakers on page 20 when placing the speakers in another room.
2Select ‘Speaker B’ from the ‘Surr Back System’ menu.
See Surround back speaker setting on page 40 to do this.
Switching the speaker system
If you selected Speaker B in Surround back speaker setting on page 40, three speaker system settings are possible using the SPEAKERS button. If you selected Normal (default) or Front
options below are for the Speaker B setting only.2
•Use the SPEAKERS button on the front panel to select a speaker system setting.
As mentioned above, if you have selected Normal (default), the button will simply switch your main speaker system (A) on or off.
Note
1• When playback from the multichannel inputs is selected, you can’t use Midnight/Loudness, Dialog Enhancement or the SIGNAL SELECT and ANALOG ATT buttons, as well as any of the listening modes (including STEREO and the surround back channel processing).
•When playback from the multichannel inputs is selected, only the volume and channel levels can be set.
•You can’t listen to your speaker B (Second Zone) system during playback from the multichannel inputs.
2 • The subwoofer output depends on the settings you made in Manual speaker setup on page 48. However, if SP B is selected above, no sound is heard from the subwoofer (the LFE channel is not downmixed).
•Depending on the settings in Surround back speaker setting on page 40 output from the surround back
•All speaker systems (except Speaker B connections) are switched off when headphones are connected.
54
En
