Voltage selector
You can find the voltage selector switch on the rear panel of
The factory setting for the voltage selector is 220 V. Please set it to the correct voltage for your country or region.
Before changing the voltage, disconnect the AC power cord. Use a medium size screwdriver to change the voltage selector switch.
220 V | 230 – 240 V |
Medium size screwdriver
Changing the TV format setting
If the System Setup menu is not displayed correctly, it may be that the TV system is set incorrectly for your country or region.
1 | With the receiver in standby, press STANDBY/ |
ON while holding down the SETUP button. | |
2 | Select PAL/NTSC using / , then select PAL or |
NTSC using / .
The display shows the new setting (PAL or NTSC).
Changing the frequency step
If you find that you cannot tune into stations successfully, the frequency step may not be suitable for your country/region. Heres how to switch the setting:
1 | With the receiver in standby, press STANDBY/ |
ON while holding down the SETUP button. | |
2 | Select FREQ.STEP using / , then select 9k or |
10k using / .
The display shows the new setting:
9k
10k