Basic Operations
Switching power ON/OFF
Switching power ON
When using the IP BUS mode
1Switch the display image source to this product.
For details, refer to the manual of the con- nected unit.
2Press SOURCE on the head unit.
Press repeatedly until source DVD is selected. For details, refer to the manual of the con- nected unit.
When using the STAND ALONE mode
1Switch the display image source to this product.
For details, refer to the manual of the con- nected unit.
2Press POWER.
Power to this product switches ON and the power indicator lights.
Note
With some discs, a menu may be displayed. (Refer to Operating the DVD menu on page 17.)
Switching power OFF
When using the IP BUS mode
%Press and hold SOURCE on the head
unit.
# When you have switched the power of this unit ON by pressing POWER, turning the head unit OFF can not switch this unit OFF.
Section
05
Note
When you have switched the power of this unit ON by pressing POWER, be sure not to forget to switch the power of this unit OFF.
When using a rear display in the | Basic | |
! Even if the source selected with the head | ||
IP BUS mode | Operations | |
unit is not source DVD, if you switch power | ||
| ||
to this product ON with POWER, you can |
| |
watch the DVD picture from this product |
| |
on the rear display. |
| |
! Regardless of whether the head unit is |
| |
switched ON/OFF, you can switch power to |
| |
this product ON/OFF. |
|
When using the STAND ALONE mode
%Press POWER.
Power to this product switches OFF and the power indicator goes out. 
Loading/Ejecting discs
Loading a disc
Up to six discs can be stored into this unit. Each disc is stored in each disc holder allow- ing you to specify a holder for loading a disc.
1Press one of the
Each of the disc holders has corresponding in- dicator. The indicator shows status of the disc and holder as the table below.
Status of disc and | Indicator | |
holder | ||
| ||
|
|
The holder is empty. | Does not light. | |
|
| |
The holder is being se- | Flashes in blue. | |
lected. | ||
| ||
|
|
En 
15
