Pioneer S-DV700ST, XV-DV900 Voltage Selector Switch, Before mounting, 240 220V –230V 110V –120V

VOLTAGE SELECTOR SWITCH

Only multi-voltage model is provided with this switch.

Always check that selector are set properly before plugging the power cord into the wall outlet.

1.Disconnect the power cord.

2.Use a small-sized screwdriver.

3.Insert the screwdriver into the groove on the voltage selector, and adjust the

VOLTAGE SELECTOR.

VOLTAGE SELECTOR

240 V

220V

–230V

110V

–120V

CAUTION 240 V

Power source voltage is factory adjusted at 240 volts. If your area is different, change the voltage selector’s setting.

H039En

On the inside cover of the unit.

Wall-mounting the center and surround speaker system

Before mounting

•Remember that the speaker system is heavy and that its weight could cause the wood screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. Make sure that the wall you intend to mount the speakers on is strong enough to support them. Do not mount on plywood or soft surface walls.

•Mounting screws are not supplied. Use screws that are suitable for the wall material and that will support the weight of the speaker.

5 mm

10 mm

5 mm

Wood screw

Protrusion: 5-7mm

•If you are unsure of the qualities and strength of the walls, consult a professional for advice.

•Pioneer is not responsible for any accidents or damage that result from improper installation.