Planar C3012T, C3013T Installing Memory, To remove an SO Dimm module, To install a SO Dimm module

Installing Memory

SO DIMM bank 0

SO DIMM bank 1

Figure 10

Do not remove the T-Bar or standoffs.

Each SO DIMM bank is wired in parallel and requires two modules. You can fill one bank or both. But you should never put just one DIMM module in a bank: the unit will malfunction.

To remove an SO DIMM module

1.Remove back housing as above.

2.Placing your hands on both sides of the T-Bar, gently open both side catches simultaneously (apply pressure to the plastic part of the catch, not the metal spring).

3.The SO DIMM module will pop up.

4.Remove the SO DIMM module.

To install a SO DIMM module

1.Remove back panel as above.

2.Placing your hands on both sides of the T-Bar, gently insert the SO DIMM module into an empty socket. Ensure correct orientation using the module notch located next to the contacts. In Bank 0 the module orientation notch will face toward the processor. In Bank 1 the module ori- entation notch will face away from the processor.

3.Push the module down gently until the side catches snap into place, coaxing them if necessary.

Technical Note: The SO DIMM module will only insert one way into the socket; do not force it. If you meet with resistance, check the orientation of the module.

8Planar Clean Screen PC User’s Manual