Chapter Three: Hardware Installation andReplacement
This chapter refers to installing or replacing options within the Clean Screen itself. Instructions
on installing the Clean Screen onto a standard Planar mounting option will come with the mount-
ing equipment itself.

Removing the Back Housing

Figure 8
Power down unit first and disconnect it from the power source.
1. Power down unit first and disconnect it from the power source.
2. Use a static-free workstation.
3. Place Clean Screen face down on a secure flat surface, using a cloth or other non-abrasive
material to protect the display.
4. Remove the twelve attachment screws from the back housing using a T25 torx driver.
5. Remove the three attachment screws from the back housing located near the connector ports
using a T15 torx driver.
6. Remove the back panel itself by gently lifting the bottom back edge first.
6Planar Clean Screen PC User’s Manual
Twelve T25 Torx screws
Four holes for standard
Planar mounting options (10⁄32)
Three T15 Torx screws
CS Manual LAYOUT#1787 3/9/98 5:33 PM Page 6