Planar PD7170 operation manual Trim Ring, Lens Motor Connector

Installation

5.Press and hold the lens release button. Then, grasp the lens by the front and rotate it counterclockwise until it stops (approximately 30 degrees).

6.Pull the lens straight out to remove it.

7.Remove the trim ring attached to the motor housing on the lens you just removed. To do this, remove the two screws and two metal clips that hold it in place.

8.Attach the trim ring to the motor housing on the new lens.

9.Note that the lens mount flange has a female socket connector for the lens motor on the right side of the flange. (The lens assembly motor has a male socket connector that mates with this connector.)

Trim Ring

Lens Motor Connector

10.Hold the replacement lens assembly with the motor facing to the right. Carefully insert the back of the lens assembly into the hole in the lens flange.

11.Slightly rotate the lens assembly counterclockwise to align the motor connectors on the lens and lens flange. Gently push the lens assembly in until it is seated flush against the flange and the motor connectors have seated.

12.Carefully rotate the lens assembly clockwise until it stops and the metal clips at the back of the lens “click” into place.

13.Replace the projector front cover.

22 Planar PD7170 Installation/Operation Manual