C o n n e c t i n g a P C o r M a c i n t o s h

Connecting a PC or Macintosh to the unit will enable you to project your computer screen images for impressive presentations.

• The following display standards are supported:

VGA 640480 for graphics

SuperVGA 800600

 

 

VGA 640350 for graphics

XGA 1024768

 

 

VGA 720350 for text

Macintosh at 640480

 

 

VGA 640400 for graphics

Macintosh at 832624

 

 

VGA 720400 for text

Macintosh at 1024768

 

 

A PC, Macintosh, or computer equipped with an XGA adapter or compatible graphics adapter can easily be connected.

If your PC does not support XGA you will need to install an XGA graphics board. Consult your computer's owner's manual for your XGA configuration. If you need to install a new board, refer to the manual supplied with your new graphics board for installation instructions.

Notes

Refer to the owner's manual supplied with your computer for more information about the video output requirements of the computer and any special identification or configuring required by the projector image and monitor.

Some Macintosh PowerBooks may need to set the mirroring to off to output 1024 768 dot signals. Please consult your PowerBook manual or computer dealer for details.

Before connecting

Turn off the computer that is to be connected.

The unit and computer will be turned on in “Using the unit” on page 15. Do not turn on either the computer or the unit until you read this section.

Please also refer to the manual of the computer to be connected.

IBM PC/AT compatible machine or

 

Macintosh with Mini D-Sub 15-pin

Macintosh desktop computer

connector

To PC’s audio jack

To Macintosh's audio jack

Mini D-Sub 15-pin connector

Monitor adapter for Macintosh

You may need to change the DIP switch setting depending on the machine to be connected. See next page.

PC/Macintosh multicable (supplied)

Mini D-Sub 15-pin connector

Mini D-Sub 15-pin connector

PC audio cable (supplied)*

PC/Macintosh multicable

(supplied)

* When VIDEO or S-VIDEO is selected as the input source, the sound from the AUDIO L/MONO /R jacks will be output.

When RGB is selected as the input source, the sound from the PC AUDIO jack will be output.

MOUSE

RGB IN

PC AUDIO S-VIDEO

VIDEO

AUDIO

L/MONO R

Plug the cable connector into the RGB IN connector securely and tighten the screws.

The unit's terminal panel

E – 12

Page 14
Image 14
PLUS Vision U2-1130/U2-1110 user manual N n e c t i n g a P C o r M a c i n t o s h, Before connecting, Connector