The horizontal and vertical positions of the image can also be adjusted manually. See page 27.
If you have set “AUTO MODE” to “OFF” to carry out the above described adjustments (see page 27 for details), you can choose to project the image at the original size of the incoming signal resolution. (Normally, the image is enlarged or reduced to the most suitable size automatically.) See page 27.
9 Adjust the picture elements (see page 28), then select the picture type according to the video content (see page 28).
10 Start using the unit.
The following functions are available while using the unit:
•Adjusting the volume of the unit's speaker (see pages 19 and 25),
•Using the laser pointer (see page 19),
•Turning off the image and muting the sound temporarily (see page 19),
•Freezing a moving picture (see page 19),
•Enlarging the picture (see page 20), and
•Enlarging the picture after selecting the portion you wish to enlarge (see page 21).
Note
If “POWER OFF” is set to “ON” (see page 29), the image will be turned off if the unit has been left unoperated for five minutes with an RGB input source.
If the image is suddenly turned off while projecting a computer image, the computer’s screen saver or power management function may be activated.
After using the unit
1 Press POWER OFF on the remote control, or POWER on the unit, for two to three seconds.
When you have turned off the unit, the POWER indicator will start flashing then turn to amber in one minute.
Never disconnect the power cable while the POWER indicator is flashing.
|
| POWER |
OFF | POWER | ON |
VIDEO | Green light flashes | |
|
| (About one minute) |
|
| ↓ |
RGB |
| Then lights steadily |
|
| in amber |
Notes
•Neither POWER ON on the remote control nor POWER on the unit operate while the POWER indicator is flashing.
•Wait at least one minute before turning on the unit again. POWER ON on the remote control or POWER on the unit may not operate if you try to turn on the unit again within one minute after turning off the unit.
2 After the POWER indicator stops flashing and turns to amber, disconnect the power cable from the wall outlet, then from the unit.
The POWER indicator goes out.
Note
Hold the plug when disconnecting the power cable. Never pull the cord.
(Continued on next page.)
E – 17
