PLUS Vision U2-1130/U2-1110 user manual E c k i n g h o u r s o f l a m p u s a g e

C h e c k i n g h o u r s o f l a m p u s a g e

The lamp cartridge must be replaced after 1000 hours of usage. When 1000 hours have elapsed the STATUS indicator will light in red (see page 32). Periodically check the hours of lamp usage in the menu so that you will have time to purchase a new lamp cartridge before the old one burns out.

1Press MENU to display the main menu.

2Press the cursor / keys to select “POWER MENU.”

3Press L-CLICK to display the POWER MENU.

4Press the cursor / keys to select “LAMP USAGE.” The lamp usage hours will be displayed.

Resetting the lamp usage hours to zero

You need to reset the lamp usage hours to zero after replacing the lamp cartridge (see page 33).

1Carry out the steps above.

2Press POWER ON on the remote control for more than ten seconds.

“LAMP USAGE” will be reset to zero and the STATUS indicator will go off (see page 32).

If the unit doesn’t turn on because lamp usage exceeds 1100 hours.

The unit is designed not to turn on after the lamp usage has exceeded 1100 hours. (If the unit is in use, it will go off.) If this happens you must replace the lamp cartridge with a new one immediately. After replacing the lamp cartridge, you need to reset the lamp usage hours to zero to enable you to turn on the unit.

1Connect the power cable (see step 1 on page 15).

2Press POWER OFF on the remote control for more ten seconds.

“LAMP USAGE” will be reset to zero and the STATUS indicator will go off (see page 32).

R e s e t t i n g t o t h e f a c t o r y s e t t i n g s

The following items can be reset to the standard settings.

•H POSITION

•V POSITION

•PICTURE ADJ

•FINE PICTURE

•BRIGHTNESS

•CONTRAST

•COLOR

•TINT

•SHARPNESS

•WHITE BALANCE

Although the above items for the particular input source are stored in memory when setting the value, the items for all input sources will be reset regardless of the input source when resetting.

1Press MENU to display the main menu.

2Press the cursor / keys to select “SETTING MENU.”

3Press L-CLICK to display the SETTING MENU.

4Press the cursor / keys to select “RESET.”

The horizontal frequency appears under “RESET” when the present input source is RGB.

5Press the cursor + key for more than three seconds.

“COMPLETED” appears under the title “RESET” after the reset is complete.

E – 30